Step1: cut the hole on the ceiling according to the specification of the downlight
Step 2: take out the trim of the downlight
Step 3: connect the driver to the main supply according to the instruction
Step 4: push the light to the ceiling
Step 5: lock the screw using an electric screw driver
Step 6: install the trim of the downlight
Step 1: Ready the lamp for installation
Step 2: Cut a hole on the roof according to the request
Step 3: Install drive power and electrical wires.Step 4: Connect the LED driver with electrical wires. Put the driver on the specified position.
Step 5: Pull up spring clips, put the lamp in the ceiling and the spring clips will be locked automatically.Step 6: Installation is complete.
Step A: Screw the two bases to the ceiling.
Step B: Remove the original screws from the four corners of the panel, and replace with new holders.
Step C: Screw the four steel wires into the holders in the panel, then pull the wire to adjust the distance between the panel and the ceiling.
Step D: Screw the steel wires into the bases in the ceiling, install the driver, and then finish.
Step A: Put together two A frames and one B frame
Step B: Screw the installed frames to the roof.
Step C: Put the LED panel light inside the frame.
Step D: Put the last frame B, install the driver, and then finish.
Step A: Remove the original screws for installating bracket A.
Step B: Put the four brackets A in their specified locations, then screw them in.
Step C: Screw the four brackets B into the ceiling. Cut a hole into the celling for power line access.
Step D: Hang brackets A on brackets B, install the driver, and then finish.
Step A: Remove the original screws.
Step B: Put the four clips into their specified positions, then screw them in.
Step C: Cut a hole according to the panel cut size, then install the driver and connect the alternating current power.
Step D: Using the clips, attach the panel light onto the roof as shown in the pictures, and then finish.